INHIBITOR C

METALWORKING FLUID ADDITIVE

 

INHIBITOR C is a copper corrosion-inhibiting additive for metalworking fluids.

 

OPERATIONS:

 

Add INHIBITOR C to metalworking fluid mixes as directed by CIMCOOL® Technical Services.

 

APPLICATION:

 

Pour INHIBITOR C directly into the “clean” side of a central filtration system where contamination is the lowest and will be least likely to reduce its effectiveness. For individual machines, add directly to the sump (machine reservoir).

 

RECOMMENDED STARTING DILUTIONS

 

FOR INDUSTRIAL USE ONLY

 

Typical Operating Range:

 

0.01% (1:10,000) 100 ppm	approximately 13 oz in 1,000 gallons
0.015% (1:7,000) 150 ppm	approximately 18 oz. In 1,000 gallons

 

For concentrations outside this range contact CIMCOOL® Technical Service at 513-458-8199.

 

TYPICAL PHYSICAL AND CHEMICAL PROPERTIES

 

Physical state	Liquid
Appearance and odor	Clear / Chemical
Solubility in water	100% Miscible
Weight, lb/gal, 60°F (15.6°C)	10.01
Specific gravity, (HO = 1)	1.200
Boiling point, °F (°C)	212 (100)
Flash point, PMCC, °F (°C)	NA
Freezing point (or pour point), °F, (°C)	-18 (-7.8)

 

If frozen thaw completely at room temperature.

 

pH, concentrate

13.2

 

HANDLING and STORAGE

 

If frozen thaw completely at room temperature. Inside storage is recommended.

 

SAFETY DATA SHEET

 

Available at www.cimcool.com

 

For additional information refer to its OSHA MSDS, website or contact your local CIMCOOL TECHNICAL SPECIALIST OR DISTRICT MANAGER, or you may contact CIMCOOL® Technical Services at 1-513-458-8199.

 

Limitation of Liability: Under no circumstances, shall we or any affiliate of ours have any liability whatsoever for loss of use, or for any indirect or consequential damages. Minor formulation changes or normal variations in the manufacture of this product may cause slight variances in the data presented on this sheet.